• New
    Thorens TD 903 TP 92 Zebrano in Geneva | Digistore.ch
    Thorens TD 903 TP 92 Zebrano in Geneva | Digistore.ch
    Thorens TD 903 TP 92 Zebrano in Geneva | Digistore.ch

Thorens TD 903 TP 92 Zebrano

63447
CHF6,790.00 Tax included
Supplier stock – typically 4 to 7 days
Thorens TD 903 suspended-subchassis turntable in zebrano, with a nine-inch TP 92 tonearm and a quartz glass platter. Supplied without a cartridge.
Quantity
Supplier delivery time usually between 4 and 7 days

The turntable in zebrano, dust cover open

Suspended triCom subchassis

The TD 903 sits on a triCom subchassis, an aluminium-POM composite chosen for its stiffness and its damping. That subchassis hangs on three conical springs whose tension is adjusted from above, which makes levelling straightforward. The AC synchronous motor is mounted directly on the damped subchassis and drives the sub-platter through a ground precision belt. Two of the three feet are also levelled from above.

The glass platter and the arm, seen close up

Quartz glass platter

The 300-millimetre platter is made of quartz glass and weighs 2.7 kilos. It sits on an aluminium sub-platter, itself carried by a sintered bronze bearing with a Teflon mirror. The steel axle running inside it generates very low but constant friction, which gives the motor a steady base load.

The setup accessories laid on the plinth

TP 92 precision tonearm

The nine-inch TP 92 arm tube is made of cold-compacted special aluminium; its own resonances were measured with a laser vibrometer and then damped where it counts. The headshell, also aluminium, is coupled to the tube over a large area and keeps the cartridge's centre of gravity under the arm axis. Overhang, azimuth and VTA height are all adjustable, and anti-skating is applied without contact by two ferrite magnets. The photograph shows the supplied setup accessories, on a deck pictured in a different finish.

The rear panel and its sockets

RCA and XLR outputs

The rear panel carries an RCA output, a balanced XLR output and a ground terminal. Power arrives as 24 volts DC through a dedicated socket, and the two speeds of 33 and 45 rpm are switched electronically. The turntable ships without a cartridge and can be brought up to TD 905 level.

63447

Data sheet

Width
470 mm
Depth
380 mm
Height
140 mm
Unit weight
10.0 kg

Specific References

EAN13
4260270990067
New

This website uses cookies to ensure you get the best experience on our website