The Void Acoustics Cyclone 8 passive speaker combines an 8-inch bass driver and a 1-inch coaxial compression driver in an IP-55 fibreglass cabinet. It has a 90° dispersion and mounts on the wall or ceiling.
An 8-inch bass driver and a 1-inch compression driver share the same axis. This coaxial source gives even dispersion across the whole listening area. The response runs from 75 Hz to 20 kHz (-10 dB), with a sensitivity of 94 dB (1 W, 1 m) and a power handling of 200 W AES.
The conical radiation pattern covers 90° both horizontally and vertically. The bass-reflex loading, with a port designed to limit turbulence noise, supports the low end. The calculated maximum level reaches 115 dB continuous and 121 dB peak. RAL or KROME shades are available on request.
The low-resonance fibreglass composite cabinet has an IP-55 protection rating, and its smooth cellulose finish resists UV. The weather-resistant input cable glands accept a Phoenix connector with a link output, which lets you daisy-chain the next speaker. The nominal impedance is 8 Ω and the manufacturer recommends a Bias Q1+ amplifier at minimum.
The T80-type mounting points accept a wide choice of wall, ceiling or pole brackets, with a large aiming range. The speaker measures 450 × 281 × 317 mm and weighs 14 kg. Its grille and hardware are stainless steel. It comes as standard in red with a black grille, black with a black grille and white with a white grille.
Data sheet
The Void Acoustics Bias Q1+ power amplifier delivers 4 x 300 W into 8 Ω in class D, in a 7 kg 1U rack chassis. Its built-in DSP is controlled with ArmoníaPlus software.
The Void Acoustics Bias Q1.5+ power amplifier offers 4 channels of 600 W into 8 Ω with built-in DSP, in a 7 kg 1U rack case. It drives low-impedance loads down to 2 Ω as well as 70 V and 100 V lines.
The Void Acoustics BIAS Q2+ is a 4-channel class D power amplifier delivering 1200 W per channel into 8 Ω. Its built-in DSP is controlled with ArmoníaPlus, in a 1U rack chassis.
The Void Acoustics BIAS Q3 power amplifier delivers 1400 W per channel into 8 Ω on four channels, with built-in DSP and a 4.3-inch touchscreen. It is controlled from the front panel or with ArmoníaPlus software, in a 2U rack format.
Français
Deutsch
Italiano
