Audeze LCD-2 | High-end planar magnetic headphones with wooden earcups

70291
CHF949.00 Tax included
24‑hour delivery

Open-back over-ear headphones with planar magnetic drivers and wooden earcups, available in two finishes.

Color : Dark Wood
Quantity
In stock

Listener sitting in an armchair wearing headphones, beside a turntable

Listening, not dissecting

The LCD-2 is the rock and roll member of Audeze's LCD line: it puts emotion ahead of analytical rigour. You stay comfortable on recordings that are technically uneven, where a more clinical headphone underlines every flaw in the take. Distortion stays below 0.1 % at 100 dB and the soundstage keeps the depth of a live room.

Earcup grille of the Audeze LCD-2 headphones seen from the side

A 106 mm driver

Behind the grille sits a 106-millimetre planar magnetic driver: an array of N50 neodymium magnets and an ultra-thin diaphragm whose surface carries the conductive traces. That large radiating area is what gives the LCD-2 its sense of space. Fazor technology guides the wave inside the earcup and corrects phase response.

Earpads and ventilated suspension headband seen from the front

595 grams, well carried

The headphone weighs 595 grams, and the ventilated suspension headband spreads that mass instead of concentrating it on the top of the head. The thick earpads hold without clamping, which matters across a full album. The leather-free Padauk finish uses the same construction in vegan materials.

Headphones with wooden rings seen at three-quarters, detachable cable connected

Wood finished by hand

The wooden rings are finished one at a time: they give the headphone its look and damp resonances inside the earcup. You receive the LCD-2 with a 1.9-metre braided cable terminated in 4-pin XLR and mini-XLR, an adapter to 6.35 mm, a second to 3.5 mm, a travel case and its certificate of authenticity.

Dark Wood = Rosewood / Leather Light Wood = Padauk / Leather-Free
70291

Data sheet

Headphone type
Open-back circumaural
Nominal impedance
70 Ohm
Sensitivity
101 dB/1 mW (at drum reference point)
Headphone design
106 mm planar magnetic, ultra-thin diaphragm, N50 neodymium magnet array, Fazor phase management
Drive type
Magnetic Planar
Frequency response
10 Hz – 50 kHz
Recommended amplifier power
250 mW recommended (100 mW minimum)
Aimant
Néodyme (NdFeB)
Cable length
1.9 m
Connector
4-pin XLR + 2× mini-XLR
Unit weight
0.6 kg
Distortion (THD)
below 0.1 % at 100 dB
Maximum SPL
above 130 dB
Power handling
5 W RMS

Specific References

EAN13
819343015042
New

This website uses cookies to ensure you get the best experience on our website