• New
EPOS ES28N in Geneva | Digistore.ch
    EPOS ES28N in Geneva | Digistore.ch

EPOS ES28N | 3-way floorstanding loudspeaker

73194
CHF3,995.00 Tax included
Supplier stock – typically 4 to 7 days
3-way EPOS ES28N floorstanding loudspeaker. Available in black, white, walnut and jade green, sold individually.
Color : White
Quantity
Add to wishlist
Supplier delivery time usually 4 to 7 days

EPOS ES28N in walnut in a living room with turntable and tube amplifier

Three-way architecture

Two 7-inch bass drivers ruled out a two-way layout: their radiating area forbids a crossover around 2 to 3 kHz, and a 2.5-way configuration would have tilted the radiation axis downwards. EPOS therefore chose a three-way with a dedicated 130 mm midrange, crossed at 330 Hz then at 2700 Hz by modified LKR filters of the 2nd and 4th order. Impedance is compensated through the midrange to suit tube amplifiers.

Pair in jade green in front of a bright graphic backdrop

Two seven-inch bass drivers

Both bass units share the motor and basket of the ES14N but take a straight cone rather than a curved one, a choice that serves the bottom end. A large inverted dust cap stiffens the diaphragm further. Aluminium demodulation rings stabilise the inductance of the 36 mm voice coil, which keeps the crossover free of modulation. The jade green finish joins black, white and walnut.

Black pair either side of a low cabinet against a concrete wall

Port under the base

The 8 cm diameter port opens under the plinth, which allows a length sufficient to tune the cabinet to 30 Hz. Pressure-equalising holes placed halfway along suppress the tube resonance and lower the parasitic output by about 10 dB compared with a conventional port. The opening in the plinth stays wide enough that the bass does not suffer if you stand the loudspeaker straight on the floor, without spikes.

White finish in a bright room, near a picture window

Tilted sandwich cabinet

The cabinet is slightly tilted to time-align the drivers. Its construction is a sandwich of two MDF panels bonded by a high-damping glue layer; the front reaches 50 mm thick, formed of two 10 mm sandwich panels and a 30 mm chambered MDF panel. The midrange has its own compartment with a triangular back, and the crossover has one of its own behind the tweeter, sheltered from high pressure.

73194

Data sheet

Product Type
3-way bass-reflex floorstanding loudspeaker
Nominal impedance
Average above 6 Ω (minimum 3.9 Ω at 16 kHz)
Sensitivity
86 dB (2.83 V / 1 m)
Tweeter
28 mm ceramic-coated aluminium dome
Midrange driver
130 mm (5.25 in) mica-filled polypropylene
Woofer
2 x 7 in mica-filled polypropylene (36 mm voice coil)
Frequency response
30 Hz - 25 kHz (in room)
Width
25 cm
Depth
36 cm
Height
105 cm
Unit weight
35 kg

Specific References

EAN13
9507124375584
New

Complete your speakers

This website uses cookies to ensure you get the best experience on our website